★★★★★
Average rating on the App Store. Apple doesn't publish how many ratings each star has.
This app isn't in any of our charts yet.
• Shared cut lists start with the job's name, and list any custom take-offs used, so the numbers can be checked. • Share a saved job's cut list without opening it: press and hold it in Saved Jobs. • Walk-out check marks stay put when you close the cut list to look at the pipe. • Deleting a saved job or resetting calibration asks first. • Set, Place and Add stay grey until the number you typed reads right, instead of quietly doing nothing. Numbers typed with a comma (4,5) work. • Building Plan: picking a job and tapping its room now works in Edit rooms too. Bigger buttons, and Rename is now Edit. • Pipe height off the floor is typed in feet and inches. • Share Plant says how many jobs go: only jobs placed in a room are sent. • A shared job with the same name as one of yours comes in as “(shared)”, so saving yours doesn't overwrite it.
Aim, tap, and PipeFitAR turns a pipe run into a cut list — take-outs and weld gaps already subtracted. Point the crosshair at the wall, ceiling or rack where the pipe goes and drop a point at each centerline change. PipeFitAR builds the run in AR, works out center-to-center for every leg, and gives you cut lengths for the fittings you picked. CUT LIST, NOT JUST A TAPE • Cut = center-to-center − fitting take-out − weld gap, per leg • ASME butt-weld elbows 1/2"–12" NPS: 45 LR, 90 LR or SR, and 90s cut to any angle • Tees, reducers, weld-neck and slip-on flanges (150# and 300#), gaskets and bolt sets • Socket-weld and threaded take-outs, couplings on straight runs (up to 2") • Pipe can sit tight to the surface, at a set standoff, or on an existing pipe's centerline HONEST ACCURACY • Run 3 or more tape tests and PipeFitAR learns how far off your phone reads • Every cut shows its ± so you know which ones to tape before cutting • Tap any cut to type the real tape C-C; a tape pass walks you through the untaped ones • Snap to level, plumb and 45° with a haptic tick when it locks ON THE JOB • Walk-out: run / roll / rise from the last mark, with check-offs • Iso sketch with C-C dims and fittings — share it as a picture • Material list: pick 20', 21', 24' or 40' joints, enter drops on hand and they get used first • Save jobs by name. With the room scan saved, the run snaps back into place when you come back • Flashlight button for dark mechanical rooms; screen stays awake PRIVATE BY DESIGN No account, no ads, no tracking. Everything stays on your iPhone. AR gets the shape; your tape gets the numbers. Measurements are estimates — verify every cut with a tape before cutting or welding. Works best on iPhone Pro models with LiDAR. Questions or a fitting you need added: support@unitus.dev